You are here

Zero colour oxide free welds for manual welders

05th December 2017

Titanium, stainless steel and other corrosion resistant materials need to be shielded with an inert gas while welding takes place, in order to protect the molten weld pool from combining with oxygen and nitrogen from the surrounding air.

Trailing Shields ATS PHO-05C Manual Flat

Without this protection, welds will oxidise and can form metallurgical defects that may cause weld joint failure.


TIG (GTAW) and Plasma (PAW) welding torches are fitted with gas cups, through which inert gas flows and protects the molten weld metal around the arc, however as the weld torch travels further along the weld seam, the  welded metal is still hot enough to oxidise as it is exposed to air.  In most cases the oxidation has to be removed to reduce the risk of weld failure.  This removal costs time and money for labour hours and materials.


In order to eliminate the air from combining with the remaining hot metal, it is possible to fit a trailing shield to the welding torch.


One company that manufactures such devices is Huntingdon Fusion Techniques Limited (HFT) and after more than 40 years of experience, they have developed a complete range of shields that cover most welding geometries of the above named materials.


Lightweight radiused models cover all diameters of pipes and cylindrical vessels.


Flat models suit sheet metal or other flat applications.


An internally radiused model is available for those welders that have to weld inside a large diameter pipe or chamber.


Larger shields with greater width and length to accommodated the higher heat input and faster speed of automatic welding.




Internally radiused model

Flat Trailing Shield®




Standard radiused model for a small diameter tube

Two special flat models with one standard flat model


Shields for manual welding are small and light in weight and easily fit onto TIG/GTAW of Plasma/PAW manual welding torches.


The Trailing Shield® is connected to an argon gas source and when the weld is started, it has extra argon flooding to the sides of the weld and covering the heat affected zone adjacent to the weld. As the welding torch is moved forward, because of the length of the Trailing Shield®, the weld remains under a cold argon gas shield until the welded metal has cooled below its oxidation temperature.


For manual welding, the welder finds that with this lightweight and low cost tool, there is no difficulty with the shield following the torch along the surface being welded. One further benefit is that it carries the welding torch at 90º to the weld. 


The HFT Argweld® range of trailing shields have a series of variable mesh layers integrated into the body that provide a smooth laminar gas flow into the protected area to prevent any air being drawn in from outside.


In addition, they have replaceable flexible silicone strip side walls to prevent entry of air while moving alongside the weld joint.


With automatic welding machines it is possible to raise the welding speed dramatically and enjoy the major benefits of automatic welding. Each Trailing Shield® is delivered with a variable diameter connector so that it can fit any size of TIG/GTAW/PAW welding torch for manual or mechanised welding.

Related topics: